公司動態
Tesla特斯拉專用診斷設備LOKI
發布時間:2025-02-06 來源: 作者:autosadmin
特斯拉汽車的維修需要特殊的診斷和維修設備。我們介紹LOKI——一種多功能診斷設備。
Loki has a complete set of functions necessary for Tesla maintenance and repair, which allow the following:
Loki擁有特斯拉維護和維修所需的全套功能,可以實現以下功能:
● to make either a complete or partial reconfiguration of a vehicle;
● 對車輛進行完全或部分重新配置;
● to install new firmware versions;
● 安裝新的固件版本;
● to install navigation and adjust the settings;
●安裝導航并調整設置
● to read, decode, and erase, when necessary, DTCs from different ECUs;
●必要時讀取、解碼和清除來自不同ECU的DTC;
● to read PIN-code with the subsequent deactivation of Valet Mode and PIN to drive;
●讀取PIN碼,隨后停用代客泊車模式,并讀取駕駛PIN碼;
● to reprogram ECUs to match them to a vehicle;
●重新編程ECU,使其與車輛相匹配;
● to adjust ECUs settings and perform their adaptation and calibration (door handles, a charging port, a radar, etc.);
● 調整ECU設置并執行其自適應和校準(門把手、充電端口、雷達等);
● other operations.
●其他操作。
The Loki set includes:
LOKI套件包括:
● cables CAN of specific configurations for Tesla Model S, Tesla Model SR, X;
●特斯拉S型、特斯拉SR型、X型特定配置的CAN電纜;
● cables LAN of specific configurations for Tesla Model S/X, Tesla Model 3.
●特斯拉Model S/X、特斯拉Model 3的特定配置的電纜局域網。
The cable must be connected to both: the device and the on-board computer. To start the work, we need to connect the computer to the Wi-Fi access point.
電纜必須連接到設備和車載計算機。為了開始這項工作,我們需要將計算機連接到Wi-Fi接入點。
返回
下一篇:沒有了

